![]() ![]() Maybe, to just apply the amp, you record that track with the amp applied into a new track. That's hard sometimes as it gets fairly complex with all the internal paths of Mixbus and the X32. The X32 channel you are using for the FX should be exclusive, it shouldn't have any other I/O options possible. I still will try the insert method again as it seems more logical to me. I now have amp modelling in line and no need to fire up the external rig. On card out page set card 1 to 9 as DI out Go to patch points select out 1 to DI out post fader Select AES (ie P16) select chan 1 to direct out on same chan. I tried that in insert 1 but got feedback, it may have been me mis routing something. If you want to use the FX in your X32 you need to treat it like any other outboard gear - make an insert in your Mixbus channel strip, send to a hardware output which is an input channel in the X32, run the FX on that channel, take its output and make it the return to your Mixbus send. There seems to be a lot of confusion re this online. I can hear the modelling on the monitors OK. IE: add guitar amp to channel 1 and in Chanel 1 in MB6 I get only the direct sound with no amp modelling. Have any of you been using this setup on Linux?Īlthough the desk has really nice effects I cannot get them to play in the DAW. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |